Whydoes speaker impedance matter? For speaker impedance to be a problem, the speaker must be mismatched with the amplifier. and it's usually stated on speaker components such as speakers cones or Tweeter drivers. If a speaker design has an efficiency rating of, say, 95 dB, then this means that for each watt of power put the speaker, it
Thespeakers are quite poor and matched to the amp at something like 3 ohms. That's not standard. An aftermarket amp and speakers will be a standard 4 ohms. The speaker sizes are somewhat standard. If you buy a set of 5.25" component speakers for the front, they will come with the kick panel speakers plus tweeters for the doors.
2way speaker systems: reverse the tweeter output crossover connections at the wire terminals and connect the tweeter like you normally would. This puts the tweeter back in phase with the woofer / bass driver. 3-way speaker systems: reverse the midrange polarity to the wire terminals for the crossover. [Optional] Adding speaker wiring labels
Thetweeter is necessary because it lets listeners hear the entire spectrum of sounds in every piece of music or film. Compared to those without them, sound sets with tweeters sound more appealing and natural. Tweeter speakers can only achieve sound positioning and stereo separation in an audio system.
Itmay improve sound quality, but it is no longer a necessity. Tweeter speakers have an outstanding frequency response and can produce sounds up to 30 kHz. In other words, tweeters do what most woofers do but with higher frequencies. Without tweeters, these sounds may be lost, but with one, you can feel these sounds through vibrations as human

itdepends dave on teh design. given that BSC loss affects woofers and midbass most it pays to have them a bit more sens. say you have a 90db tweeter and a 93db woofer you can apply a BSC ckt and still manage a speaker that is about 89db. however if you have a 93db tweeter and a 90 db woofer then you have to fist BSC the woofer to about 86db or less and the pad the tweeter to 86db too. yes 6db

Horntweeter models are usually technically not true tweeters because many have a frequency response that includes midrange frequencies. Unlike piezo drivers, they do need a high pass speaker crossover. Compression drivers have a small throat (output) often threaded to screw into a horn waveguide. Most use a standard magnet & voice coil design with a dome made from anything such as Mylar, silk

Passivecrossovers don't require power and offer limited control over the volume of each channel. They limit control by allowing the tweeter volume to be adjusted relative to the woofer volume. They are placed between the amplifier and the speakers or sub and, as such, take an already amplified signal to the right driver. eEE8v.
  • fv595kzb35.pages.dev/487
  • fv595kzb35.pages.dev/448
  • fv595kzb35.pages.dev/179
  • fv595kzb35.pages.dev/188
  • fv595kzb35.pages.dev/80
  • fv595kzb35.pages.dev/204
  • fv595kzb35.pages.dev/88
  • fv595kzb35.pages.dev/231

    • what does a tweeter do in a speaker